Heat-glo-fireplace 8000TV-OAK Manuel d'utilisateur télécharger pdf (Page 27)

Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. N • 11/08 27

Installing Vent Pipe

A. Assembly of Vent Sections

This B-Vent appliance requires 6 inch B-vent double-wall

pipe. Follow the pipe manufacturer’s installation guidelines

when installing the unit. This will ensure proper operation

and prevent safety hazards.

WARNING! Risk of Fire/Exhaust Fumes! Assemble

pipe sections per B-vent manufacturer’s instructions. Use

support tabs for screws. Pipe may separate if not properly

joined.

B. Attaching Vent to Firebox

Attach the ﬁ rst B-Vent component to the ﬂ ue outlet collar

using 3 self-tapping screws. See Figure 10.1.

Figure 10.1

C. Securing Vent Sections

Secure vent sections with vent supports following B-vent

manufacturer’s instructions.

WARNING! Risk of Fire or Explosion! Use vent run sup-

ports per vent manufacturer’s installation instructions.

• Connect vent sections per vent manufacturer’s

installation instructions.

• Maintain all clearances to combustibles. Maintain

speciﬁ ed slope (if required).

• Improper support may allow vent to sag or separate.

B-VENT

SECURING

SCREWS

FLUE OUTLET

COLLAR

D. Install Attic Insulation Shield

WARNING! Fire Risk. DO NOT allow loose materials or

insulation to touch vent. Hearth & Home Technologies

Inc. requires the use of an attic shield.

The National Fuel Gas Code ANSI Z223.1 and NFPA 54

requires an attic shield constructed of 26 gauge minimum

metal that extends at least 2 in. (51 mm) above insulation.

Attic shields must meet speciﬁ ed clearance and be se-

cured in place.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Pas de commentaire

Heat-glo-fireplace 8000TV-OAK Manuel d'utilisateur Page 27