Heat-glo-fireplace Heat & Glo Fireplace 8000TVC Manuel d'utilisateur télécharger pdf (Page 21)

Positioning the Logs

If the gas logs have been factory installed they should

not need to be positioned.

If the logs have been packaged separately, refer to

the installation instructions that accompany the logs.

Save the log instructions with this manual.

If sooting occurs, the logs might need to be repositioned

slightly to avoid excessive flame impingement.

Placing the Ember Material

Ember material is shipped with this gas fireplace:

 The bag containing the Glowing Embers (050-721)

is standard glowing ember material.

To place the ember material:

 Pull the four glass latches out of the groove on the

glass frame.

 Remove the glass door from the unit.

 Cover the top of the burner with a single layer of

ember material. For best performance do not

place embers on the ports on the rear of the

burner.

 Save the remaining ember materials for use during

fireplace servicing.

 Replace the glass door and a front trim door on the

unit (see Replacement Parts Section of the manual.)

 Pull out and latch the glass clips into the groove on

the glass frame.

Installing the Trim

Combustible materials may be brought up to the

specified clearances on the side and top front edges of

the fireplace, but MUST NEVER overlap onto the front

face. The joints between the finished wall and the

fireplace top and sides can only be sealed with a 300

F. (149

C) minimum sealant.

WARNING: WHEN FINISHING THE

FIREPLACE, NEVER OBSTRUCT OR

MODIFY THE AIR INLET/OUTLET GRILLES IN

ANY MANNER.

Install optional marble and brass trim surround kits as

desired. Marble, brass, brick, tile, or other non-

combustible materials can be used to cover up the gap

between the sheet rock and the fireplace.

Do not obstruct or modify the air inlet/outlet grilles.

When overlapping on both sides, leave enough space

so that the bottom grille can be lowered and the trim

door removed.

Step 11

Installing Trim,

Logs, and

Ember Material

1 2 ... 16 17 18 19 20 21 22 23 24 25

Commentaires sur ces manuels

Pas de commentaire

Heat-glo-fireplace Heat & Glo Fireplace 8000TVC Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Four Heat-glo-fireplace Heat & Glo Fireplace 8000TVC