Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11 11
Matching Security Codes
It may be necessary to program the control module to the
security code of the remote upon initial use, if batteries
are replaced, or if a replacement control module is pur-
chased from your dealer. To program the control module:
• Push the LEARN button located next to the four pin LED
connector on
the control module. (Refer to Figure 13.1
for location of button.)
• The LED located between the control module connectors
will fl ash.
• Then press the power button on the remote.
System Operation
• POWER BUTTON (bottom button)
- Pressing the POWER button will energize the LED
lights circuit at the last stored speed and/or paused
color and light the burner on high. The burner will
always light in the high fl ame position.
- Pressing the POWER button again will turn OFF the
LED lights and BURNER.
NOTE: If you are unsuccessful in matching the security
code on the fi rst attempt, wait 1-2 minutes before trying
again.
The LED will turn OFF to indicate the remote’s code has
been programmed into the control module. When an
existing receiver is matched to a new transmitter, the new
security control module will overwrite the old one.
• SPEED BUTTON (second from bottom)
- Each press of the SPEED button will sequence the
LED lights through four fi xed speeds and an OFF
mode.
- The color fade speed will be stored ten seconds after
each speed change.
- If the POWER is OFF – The SPEED button will have
no effect.
• FLAME BUTTON (second from top)
- Each press of the FLAME button will sequence the
BURNER from HIGH fl ame to LOW fl ame to OFF to
HIGH fl ame.
- Use this feature to provide LUX illumination without
heat.
- If the POWER is OFF – The FLAME button will have
NO effect.
• PAUSE BUTTON (top button)
- Each press of the PAUSE button will toggle the LED
lights color change from fi xed color to fading color
and back to fi xed color.
- The color will be stored ten seconds after each
pause.
H. Before Lighting Fireplace
Before operating this fi replace for the fi rst time, have a
qualifi ed service technician:
• Verify all shipping materials have been removed from
inside and/or underneath the fi rebox.
• Review proper placement of decorative steel log assembly,
glass rock and/or other decorative materials.
• Check the wiring.
• Check the air shutter adjustment.
• Ensure that there are no gas leaks.
• Ensure that the glass is sealed and in the proper position
and that the integral barrier is in place.
WARNING! Risk of Fire or Asphyxiation! DO NOT oper-
ate fi replace with fi xed glass assembly removed.
Remote
POWER BUTTON
SPEED BUTTON
FLAME BUTTON
PAUSE BUTTON
Commentaires sur ces manuels