Heat-glo-fireplace LUX60 Manuel d'utilisateur télécharger pdf (Page 49)

Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11 49

Appliance Setup

Glass

Latches

Figure 15.1 Glass Assembly Removal

A. Remove Glass Assembly

WARNING! Risk of Asphyxiation! Handle ﬁ xed glass

assembly with care. Inspect the gasket to ensure it is

undamaged and inspect the glass for cracks, chips or

scratches.

• DO NOT strike, slam or scratch glass.

• DO NOT operate ﬁ replace with glass removed, cracked,

broken or scratched.

• Replace as a complete assembly.

B. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated

inside the ﬁ rebox or underneath in the control cavity.

WARNING! Risk of Fire and Electric Shock!

Use ONLY

Hearth & Home Technologies-approved optional acces-

sories with this appliance. Using non-listed accessories

could result in a safety hazard and will void the warranty.

The glass assembly can be removed from the unit by

pulling and releasing the glass latches. There are three

across the top, three across the bottom, and one in the

center of each side.

The glass assembly is heavy. Use caution when remov-

ing.

C. Air Shutter Access & Adjustment

• Outside Burner Tube Air Shutter

- Disconnect power to ﬁ replace.

- Remove the “L” plates and inner surround frame

(see surround install). This will make the valve

compartment and glass accessible. (Refer to Section

3.A. Glass Cleaning.)

Note: Mark and note burner tube locations.

They are not interchangeable (Figure 15.2).

RH Burner Tube

LH Burner Tube

Back Burner Tube

1 1/4 in.

1 7/8 in.

2 3/8 in.

Back

Figure 15.2 Burner Tube ID

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Heat-glo-fireplace LUX60 Manuel d'utilisateur Page 49

Commentaires sur ces manuels

Produits connexes et manuels pour Four Heat-glo-fireplace LUX60