Heat-glo-fireplace LUX60 Manuel d'utilisateur télécharger pdf (Page 36)

Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/1136

B. Assemble Slip Sections

WARNING! Risk of Fire or Asphyxiation! Overlap pipe

sections at least 1 1/2 in. (38 mm). Secure slip sections

with two screws which must not exceed 1/2 in. (13 mm)

in length. Use the pilot holes. Pipe could separate if not

properly joined.

• Slide the inner ﬂ ue of the slip section into the inner ﬂ ue of

the pipe section and the outer ﬂ ue of the slip section over

the outer ﬂ ue of the pipe section. See Figure 10.5.

• Slide together to the desired length.

Figure 10.5 Slip Section Pilot Holes

Figure 10.6 Screws into Slip Section

NOTICE: When installing a vent system with an HRC

termination cap, all pipe system joints shall be sealed using

a silicone sealant with a minimum of 300ºF continuous

exposure rating.

• Apply a bead of silicone sealant inside the female outer

pipe joint prior to joining sections.

• Only outer pipes are sealed, sealing the inner ﬂ ue is not

required.

• All unit collar, pipe, slip section, elbow and cap outer ﬂ ues

shall be sealed.

• Continue adding pipe as necessary following instructions

in “Assemble Pipe Sections.”

NOTICE: If slip section is too long, the inner and outer ﬂ ues

of the slip section can be cut to the desired length.

• Maintain a 1-1/2 in. (38 mm) overlap between the slip

section and the pipe section.

• Secure the pipe and slip section with two screws no

longer than 1/2 in. (13 mm), using the pilot holes in the

slip section. See Figure 10.6.

Figure 10.7 Securing Vertical Pipe Sections

Figure 10.8 Securing Horizontal Pipe Sections

C. Secure the Vent Sections

• Vertical runs of pipe must be supported every 8 ft. (2.44

m) after the 25 ft. (7.62 m) maximum unsupported

rise.

• Horizontal sections of vent must be supported every 5 ft.

(1.52 m) with a vent support or plumber’s strap.

• Wall shield ﬁ restops may be used to provide horizontal

support.

• Vent support or plumber’s strap (spaced 120° apart)

may be used for support. See Figures 10.7 and 10.8.

WARNING! Risk of Fire, Explosion or Asphyxi-

ation! Improper support may allow vent to sag and

separate. Use vent run supports and connect vent

sections per installation instructions. DO NOT allow

vent to sag below connection point to appliance.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Heat-glo-fireplace LUX60 Manuel d'utilisateur Page 36

Commentaires sur ces manuels

Produits connexes et manuels pour Four Heat-glo-fireplace LUX60