Heat-glo-fireplace LUX60 Manuel d'utilisateur télécharger pdf (Page 7)

Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11 7

C. BTU Speciﬁ cations

MODELS: LUX60

LABORATORY: Underwriters Laboratories, Inc. (UL)

TYPE: Vented Gas Fireplace Heater

STANDARD: ANSI Z21.88b-2008 • CSA 2.33b-2008

E. Noncombustible Materials Speciﬁ cation

Material which will not ignite and burn. Such materials are

those consisting entirely of steel, iron, brick, tile, concrete,

slate, glass or plasters, or any combination thereof.

Materials that are reported as passing ASTM E 136,

Standard Test Method for Behavior of Materials in a

Vertical Tube Furnace at 750 ºC and UL763 shall be

considered noncombustible materials.

NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.

This appliance is tested and approved as either supplemental

room heat or as a decorative appliance. It should not be fac-

tored as primary heat in residential heating calculations.

D. High Altitude Installations

NOTICE: If the heating value of the gas has been reduced,

these rules do not apply. Check with your local gas utility or

authorities having jurisdiction.

When installing above 2000 feet elevation:

• In the USA: Reduce input rate 4% for each 1000 feet

above 2000 feet.

• In CANADA: Reduce input rate 10% for elevations

between 2000 feet and 4500 feet. Above 4500 feet,

consult local gas utility.

Check with your local gas utility to determine proper

oriﬁ ce size.

Listing and Code Approvals

A. Appliance Certiﬁ cation

G. Electrical Codes

NOTICE: This appliance must be electrically wired

and grounded in accordance with local codes or, in the

absence of local codes, with National Electric Code

ANSI/NFPA 70-latest edition or the Canadian Electric

Code CSA C22.1.

• A 110-120 VAC circuit for this product must be protected

with ground-fault circuit-interrupter protection, in

compliance with the applicable electrical codes, when

it is installed in locations such as in bathrooms or near

sinks.

B. Ceramic Glass Speciﬁ cations

This appliance is equipped with 5 mm ceramic glass. Re-

place glass with 5 mm ceramic glass. Please contact your

dealer for replacement glass.

F. Combustible Materials Speciﬁ cation

Materials made of or surfaced with wood, compressed

paper, plant ﬁ bers, plastics, or other material that can ig-

nite and burn, whether ﬂ ame proofed or not, or plastered

or unplastered shall be considered combustible materials.

NOTICE: This installation must conform with local codes

or, in the absence of local codes, with the National Fuel

Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and

Propane Installation Code, CSA B149.1.

• A manufactured home (USA only) or mobile home OEM

installation must conform with the (U.S.) Manufactured

Home Construction and Safety Standard, Title 24 CFR,

Part 3280 or, when such a standard is not applicable, the

Standard for Fire Safety Criteria for Manufactured Home

Installation Sites and Communities, ANSI/NFPA 501A,

in the United States, or the Mobile Homes Standard,

CAN/CSA Z240 MH Series in Canada.

• This appliance complies with the installation requirements

for HUD.

LUX60 - IPI

Max / Min Input Rate 60,000 / 40,000

Oriﬁ ce Size - Outside (3) #44 / .086

Oriﬁ ce Size - Center (1) #53 / .059

Max / Min Input Rate 50,000 / 37,000

Oriﬁ ce Size - Outside (3) #56 / .046

Oriﬁ ce Size - Center (1) #72 / .025

1 2 3 4 5 6 7 8 9 10 11 12 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Heat-glo-fireplace LUX60 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Four Heat-glo-fireplace LUX60